HP X360 removing the base enclosure

Removing the base enclosure

WARNING:Make sure the computer is disconnected from power before starting.

Follow the steps in this section to remove the base enclosure.

Step 1 Remove the two rubber feet from the rear corners of the base enclosure.
Step 2 Remove four screws that secure the base enclosure to the top cover. NOTE:The four screws in this step and the seven screws in the next step are different sizes. Take care to keep them separate for reinstallation.
Step 3 Remove seven more screws that secure the base enclosure to the top cover.
Step 4 Starting with the edge of the base enclosure near the power button, carefully release the retention clips on the outer edges of the base enclosure from the top cover.
Step 5 Lift the base enclosure off the computer by prying it up and lifting...
...taking care to flex the base enclosure as necessary to remove the enclosure from over the HDMI connector.
Step 6 Lift the base enclosure until you have access to the ribbon cable and its connector.
Step 7 Carefully lift up the locking bar on the connector. CAUTION:Use care to prevent damaging the connector and ribbon cable.
Step 8 Remove the cable from the connector, and lift off the base enclosure.

Replacing the base enclosure

Use the steps in this section to replace the base enclosure.

Step 1 If installing a new base enclosure, remove the USB board from the inside of the old enclosure and install it on the inside of the new base enclosure.
Step 2 Place the base enclosure over the computer so that the USB cable can be reconnected.
Step 3 Insert the ribbon cable in the connector and push down on the locking bar to secure it.
Step 4 Replace the base enclosure ensuring that the HDMI connector fits in its intended opening on the side of the base enclosure...
...and lower the base enclosure onto the computer.
Step 5 Press down on the edges of the enclosure to snap it into place.
Step 6 Replace seven screws that secure the base enclosure.
Step 7 Replace the other four screws that finish securing the base enclosure to the computer.
Step 8 Replace the two rubber feet.